[. . . ] You can connect more lamps to the remote in the same way (up to 50 lamps can be connected). Creating your personal ambience with light Remote Control Light Selection Off/On Colour selection Saturation Up Saturation Down With LivingColors products, you can create your ambience by: 1. [. . . ] Selecting and adjusting individual lamps If you have connected several lamps to this remote control, you can control them all together or individually. When selected, the lamp will flash and the light selection indicator on the remote control (light bulb) will light up. When no lamp is selected (light selection indicator is off), all your adjustments will apply to all lamps connected to the remote control (for example, you can dim all lights in the room). O A lamp is not providing light o Check the connections of the cord to the lamp. If the lamp briefly turns on and then goes off, use the remote control to switch it back on. A lamp is not responding to the remote control o Link the remote to the lamp by following the procedure described in section 1 of this manual. The batteries should be correctly loaded (+ and -) and should be charged. If the remote control is still not working, try replacing the batteries. O Make sure that the lamp you are trying to connect to the remote control has a SmartLink logo on the box. Only products with a SmartLink logo on the box can be connected to this remote. Buttons are flashing after I have used the remote control o This means that the batteries in the remote control are (almost) empty and need to be replaced. I cannot start the automatic colour changing mode o It could be that the remote control did not understand your "sweep" movement. [. . . ] They must be handed in at an official collection point or at a Philips Dealer, both of which will dispose of the batteries in an environmentally friendly way. Du kan ansluta fler lampor till fjärrkontrollen på samma sätt (upp till 50 lampor kan anslutas). [. . . ]